no drill curtain rod brackets for vertical blinds

NO DRILL CURTAIN ROD BRACKETS FOR VERTICAL BLINDS INSTALL

Purchase curtain rod brackets or holders at least 1/2 inch longer than the distance the vertical blinds stick out from the window opening when drawn. Measure how far the slats stick out from the window opening. Pull the blinds open so that the slats are perpendicular to the window. Attach the cord or wand and clip the slats, also known as vanes, to the installed clips. Attach the head rail to the brackets according to manufacturer directions some snap into place while others require screws.

NO DRILL CURTAIN ROD BRACKETS FOR VERTICAL BLINDS INSTALL

Because inside-mounted blinds naturally install through the window’s header, there’s no need for wall anchors.Īssemble the head rail, if necessary, and secure the vane clips in place. Repeat with each point, working your way from the left end of the line to the right.ĭrill pilot holes slightly smaller than the screws provided with the brackets, and install the brackets. Center the first bracket on the first point, and mark the screw holes. Follow the manufacturer directions regarding spacing. Hold a straightedge or level against the line and make marks indicating the center point of each bracket. The directions that came with your vertical blinds note the ideal distance between the glass and the brackets for the head rail, generally between 1 1/2 and 2 1/2 inches. Draw a level line between these two marks.

Mark the point with a pencil and repeat on the right side. Measure, from the back of the window opening to the front on the left side, the distance recommended by the manufacturer for the head rail. Measure from the bottom of the curtain clip in the blind’s head rail down to the floor to find the ideal length for the panels. This eliminates the need for an additional rod. When hanging outside-mounted vertical blinds with curtains, opt for a double track behind the valance that allows you to clip curtain panels in place. The gentle swoop this creates softens the vertical blinds and may make it easier to open and close the vanes during the day.

Place decorative holdbacks on the left and right sides of the window to pull the curtains back.

No drill curtain rod brackets for vertical blinds